SN74AC574PWR

SN74AC574PWR Overview

The package is in the form of 20-TSSOP (0.173, 4.40mm Width). D flip flop is embedded in the Cut Tape (CT) package. T flip flop uses Tri-State, Non-Invertedas the output. This trigger uses the value Positive Edge. There is an electric part mounted in the way of Surface Mount. The supply voltage is set to 2V~6V. Temperature is set to -40°C~85°C TA. This logic flip flop is classified as type D-Type. It is a type of FPGA belonging to the 74AC series. Its output frequency should not exceed 153MHz. D latch consists of 1 elements. A total of 20terminations have been recorded. JK flip flop belongs to 74AC574 family. A voltage of 3.3V is used to power it. Its input capacitance is 4.5pF farads. An electronic device belonging to the family ACcan be found here. A part of the electronic system is mounted in the way of Surface Mount. As you can see from the design, it has pins with 20. This device's clock edge trigger type is Positive Edge. It is included in Bus Driver/Transceiver. It is designed with 8bits. It reaches 6Vwhen the maximum supply voltage (Vsup) is applied. Normally, the supply voltage (Vsup) should be kept above 2V. The superior flexibility of this product is achieved by using 8 circuits. As a result of its reliability, this D flip flop is ideally suited for TR. The D flip flop is embedded with 2ports. In addition to its maximum design flexibility, the output current of the T flip flop is 24mA. It is reported that there are 3 input lines. There is 4μA quiescent current consumption by it.

SN74AC574PWR Features

Cut Tape (CT) package
74AC series
20 pins
8 Bits

SN74AC574PWR Applications

There are a lot of Texas Instruments SN74AC574PWR Flip Flops applications.

• Clock pulse
• Set-reset capability
• Shift Registers
• Reduced system switching noise
• ESD performance
• Computing
• Matched Rise and Fall
• Data Synchronizers
• Supports Live Insertion
• Individual Asynchronous Resets