MC74ACT564DWR2

MC74ACT564DWR2 Overview

The flip flop is packaged in a case of 20-SOIC (0.295, 7.50mm Width). Package Tape & Reel (TR)embeds it. Currently, the output is configured to use Tri-State, Inverted. It is configured with a trigger that uses a value of Positive Edge. Surface Mountis in the way of this electric part. It operates with a supply voltage of 4.5V~5.5V. In this case, the operating temperature is -40°C~85°C TA. It belongs to the type D-Typeof flip flops. In this case, it is a type of FPGA belonging to the 74ACT series. It should not exceed 85MHzin terms of its output frequency. The list contains 1 elements. It consumes 8μA of quiescent Currently, there are 20 terminations. JK flip flop belongs to 74ACT564 family. Power is supplied from a voltage of 5V volts. JK flip flop input capacitance is 4.5pF farads. This D flip flop belongs to the family of ACT. Surface Mount mounts this electronic component. 20pins are included in its design. It has a clock edge trigger type of Positive Edge. This part is included in FF/Latches. It is designed with 8bits. The superior flexibility of this circuit is achieved by using 8 circuits. In view of its reliability, this D flip flop is a good fit for TAPE AND REEL. In order for the device to operate, it requires 5V power supplies. There are 2 ports embedded in the flip flops. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. It operates with 3 output lines.

MC74ACT564DWR2 Features

Tape & Reel (TR) package
74ACT series
20 pins
8 Bits
5V power supplies

MC74ACT564DWR2 Applications

There are a lot of ON Semiconductor MC74ACT564DWR2 Flip Flops applications.

• Computers
• Individual Asynchronous Resets
• Modulo – n – counter
• Memory
• Storage Registers
• Convert a momentary switch to a toggle switch
• Power down protection
• Latch
• Guaranteed simultaneous switching noise level
• Balanced Propagation Delays