DM74ALS574AWM

DM74ALS574AWM Overview

As a result, it is packaged as 20-SOIC (0.295, 7.50mm Width). A package named Tubeincludes it. The output it is configured with uses Tri-State, Non-Inverted. This trigger is configured to use Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis required for its operation. It is operating at 0°C~70°C TA. There is D-Type type of electronic flip flop associated with this device. In this case, it is a type of FPGA belonging to the 74ALS series. Its output frequency should not exceed 35MHz. A total of 1 elements are present. It consumes 18mA of quiescent current without being affected by external factors. D latch belongs to the 74ALS574 family. There is an electronic component mounted in the way of Surface Mount. This board has 20 pins. In this device, the clock edge trigger type is Positive Edge. Due to its superior flexibility, it uses 8 circuits. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. There are no output lines on the JK flip flop.

DM74ALS574AWM Features

Tube package
74ALS series
20 pins

DM74ALS574AWM Applications

There are a lot of ON Semiconductor DM74ALS574AWM Flip Flops applications.

• Buffered Clock
• Cold spare funcion
• High Performance Logic for test systems
• Divide a clock signal by 2 or 4
• Data transfer
• Reduced system switching noise
• ESCC
• Pattern generators
• Memory
• Storage Registers