DM74ALS273N

DM74ALS273N Overview

In the form of 20-DIP (0.300, 7.62mm), it has been packaged. You can find it in the Tubepackage. The output it is configured with uses Non-Inverted. The trigger it is configured with uses Positive Edge. This electronic part is mounted in the way of Through Hole. With a supply voltage of 4.5V~5.5V volts, it operates. It is operating at 0°C~70°C TA. D-Typedescribes this flip flop. JK flip flop is a part of the 74ALSseries of FPGAs. This D flip flop should not have a frequency greater than 35MHz. The element count is 1 . Despite external influences, it consumes 20mAof quiescent current. The 74ALS273family includes it. It is mounted by the way of Through Hole. This board has 20 pins. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. Using 8 circuits, it is highly flexible. Optimal efficiency requires a supply voltage of 5V. In addition to its maximum design flexibility, the output current of the T flip flop is 24mA.

DM74ALS273N Features

Tube package
74ALS series
20 pins

DM74ALS273N Applications

There are a lot of ON Semiconductor DM74ALS273N Flip Flops applications.

• Frequency Divider circuits
• Safety Clamp
• Modulo – n – counter
• Single Down Count-Control Line
• Bus hold
• Single Up Count-Control Line
• ESD performance
• Load Control
• Differential Individual
• Balanced Propagation Delays