74F823SPC

74F823SPC Overview

24-DIP (0.300, 7.62mm)is the way it is packaged. D flip flop is included in the Tubepackage. In the configuration, Tri-State, Non-Invertedis used as the output. In the configuration of the trigger, Positive Edgeis used. Through Holeis occupied by this electronic component. It operates with a supply voltage of 4.5V~5.5V. In the operating environment, the temperature is 0°C~70°C TA. There is D-Type type of electronic flip flop associated with this device. In this case, it is a type of FPGA belonging to the 74F series. Its output frequency should not exceed 160MHz Hz. A total of 1 elements are present. It consumes 100mA of quiescent JK flip flop belongs to 74F823 family. A part of the electronic system is mounted in the way of Through Hole. The 24pins are designed into the board. This device has Positive Edgeas its clock edge trigger type. There are 9bits in this flip flop. The superior flexibility is achieved through the use of 9 circuits. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. It operates with 1 output lines. Currently, there are 2 input lines present. A high level output current of -3mAis set. 24mAis set as the low level output current. If the operating temperature is lower than 70°C, it is recommended. Operating temperatures should be above 0°C. The RS flip flop is designed to operate with a minimal supply voltage of 4.5VV. It supports the maximal supply voltage of 5.5V. A frequency of 160MHzcan be achieved.

74F823SPC Features

Tube package
74F series
24 pins
9 Bits

74F823SPC Applications

There are a lot of ON Semiconductor 74F823SPC Flip Flops applications.

• Frequency division
• Synchronous counter
• ESD protection
• Dynamic threshold performance
• Shift registers
• Balanced Propagation Delays
• Latch
• ESCC
• ATE
• Load Control