74F821SCX

74F821SCX Overview

The flip flop is packaged in a case of 24-SOIC (0.295, 7.50mm Width). D flip flop is embedded in the Tape & Reel (TR) package. As configured, the output uses Tri-State, Non-Inverted. The trigger it is configured with uses Positive Edge. Surface Mountis in the way of this electric part. A 4.5V~5.5Vsupply voltage is required for it to operate. In this case, the operating temperature is 0°C~70°C TA. Logic flip flops of this type are classified as D-Type. JK flip flop belongs to the 74Fseries of FPGAs. It should not exceed 150MHzin its output frequency. A total of 1elements are present in it. There is a consumption of 100mAof quiescent energy. In 24terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. A voltage of 5V is used as the power supply for this D latch. In terms of electronic devices, this device belongs to the F/FASTfamily of devices. It reaches 5.5Vwhen the supply voltage is maximal (Vsup). Normal operation requires a supply voltage (Vsup) above 4.5V. The flip flop has 2ports embedded within it.

74F821SCX Features

Tape & Reel (TR) package
74F series

74F821SCX Applications

There are a lot of Rochester Electronics, LLC 74F821SCX Flip Flops applications.

• Test & Measurement
• Parallel data storage
• High Performance Logic for test systems
• ESD performance
• Convert a momentary switch to a toggle switch
• Matched Rise and Fall
• Single Up Count-Control Line
• Bounce elimination switch
• Storage Registers
• Common Clocks