74ACT823SC

74ACT823SC Overview

In the form of 24-SOIC (0.295, 7.50mm Width), it has been packaged. It is contained within the Tubepackage. There is a Tri-State, Non-Invertedoutput configured with it. This trigger uses the value Positive Edge. The electronic part is mounted in the way of Surface Mount. The supply voltage is set to 4.5V~5.5V. In the operating environment, the temperature is -40°C~85°C TA. There is D-Type type of electronic flip flop associated with this device. The 74ACTseries comprises this type of FPGA. Its output frequency should not exceed 158MHz. There are 1 elements in it. As a result, it consumes 80μA quiescent current. If you search by 74ACT823, you will find similar parts. The input capacitance of this T flip flop is 4.5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. A part of the electronic system is mounted in the way of Surface Mount. A total of 24pins are provided on this board. A Positive Edgeclock edge trigger is used in this device. Despite its superior flexibility, it relies on 9 circuits to achieve it. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. There are 3 output lines in this JK flip flop.

74ACT823SC Features

Tube package
74ACT series
24 pins

74ACT823SC Applications

There are a lot of ON Semiconductor 74ACT823SC Flip Flops applications.

• Guaranteed simultaneous switching noise level
• Bus hold
• Buffered Clock
• Pattern generators
• Set-reset capability
• Storage Registers
• Reduced system switching noise
• Counters
• Clock pulse
• Balanced Propagation Delays